3Par 7000 Zoning Confusion

Since the 7000’s came out I’ve noticed a lot of conflicting information on the way HP recommends zoning to be configured.  For instance, on page 5 in the HP 3PAR StoreServ Storage and VMware vSphere 5 best practices it is clearly written that on 3.1.2 HP supports both Single Initiator->Single Target and Single Initiator/Multiple Target.  Now, before we go further lets take a look at the difference on a visual level.  Below we have two pictures from the aforementioned document.  Both pictures show a single host with two ports (Two Initiators), a set of Fabrics, and a dual node array with 2 ports each (two targets per node).

image
*Single Initiator/Single Target (RECOMMENDED)

 

image
*Single Initiator/Multiple Target (AVOID)

Now, looking at this and other HP documents out there one could quickly determine that Single Initiator->Multiple Targets would be the right configuration especially since a line on page 5 reads – “Single initiator to multiple targets per zone (zoning by HBA). This zoning configuration is recommended for HP 3PAR StoreServ Storage. Zoning by HBA is required for coexistence with other HP Storage arrays.”   So, after creating my 7000 Installation post I received some interesting feedback on several people who thought that performing the Single Initiator/Single Target method was always the recommended way from 3Par.  I verified the existence of confusion out there by looking a few 3Par installs and found it interesting that configuration methods were pretty much split 50/50 from Hp techs.  Of course, this creates a bunch of confusion since you would believe that a published HP document on the VMware site would provide the iron clad answer.  With the 7000 being approved for customers to self install I started to get more concerned about possible misconfigurations out in the field.  At this point I engaged two incredibly smart 3Par guys, Ivan Iannacone (Worldwide 3Par Product Manager) and Jorge Mastre, one of New York’s top 3Par Specialist and all around larger than life guy (those who know him will not questions this statement).

Ivan and Jorge pretty much gave the same recommendations and acknowledged the confusion in the field from conflicting documents.  They state HP will support Single Initiator –> Multiple Target but you should not have more than two targets attached to that Single Initiator.  So, if I have a quad/octo controller arrays, zoning all nodes’ targets to a single initiator can cause severe performance issues in certain case when data is coming from many WWN’s.  There are actually many performance related tickets that have been resolved due to this type of configuration.  The consensus is to just use Single Initiator –> Single Target zoning which also reduces RSCN broadcasting that can occur when presenting/removing VLUNS/HOSTS.  Sure, this process takes much longer since you will be creating more zones but this will be a pain to change once you are in production mode.

HP is working on cleaning up the inconsistencies on the article and in the meantime this document seems to be the best one to look at – http://h20195.www2.hp.com/v2/GetDocument.aspx?docname=4AA4-4545ENW&doctype=w

I hope to receive more feedback from the field on this topic and will update accordingly.

-Justin Vashisht (3cVguy)

, , ,

No comments yet.

Leave a Reply

Time limit is exhausted. Please reload the CAPTCHA.

Powered by WordPress. Designed by Woo Themes